Oetiker Two-Piece Worm Drive Clamp | W4 (AISI 304) | 12,2 mm
Brand:
Oetiker
| Article number: | OTK-18000118 |
| SKU: | 18000118 |
- 2 year warranty
- Delivery time: On request
Information
Oetiker Two-Piece Worm Drive Clamp | W4 (AISI 304) | 12,2 mm
This Worm screw clamp consists of 2 parts and functions as the lock of a broadband clamp to connect 2 pipe parts, for example. With a spot welder you weld each part of the lock with a part of your broadband. Because the clamp consists of 2 parts, the broadband clamp is now easy to apply!
Screw Clamp design Flap lock
After opening the body, the band can be formed by hand to approximately the clamping diameter. The flap can then be closed, and the clamp tightened by turning the screw. As a result, the screw only has to be turned for the last part of the clamping operation.
Intermediate stop
The flap is secured by an intermediate stop. Even when loosely assembled, clamps cannot open on their own accord.
Visual overload protection
The housing incorporates a web which distorts visibly above a tightening torque of 4–5 Nm (35–44 in-lbs). This visual feature indicates that a Worm Drive Clamp is optimally tightened and still has an adequate factor of safety to the maximum tightening torque.
Assembly Recommendations
For safe tightening of screw clamps, we recommend use of a 5A/F hexagon wrench. The maximum static tightening torque is 6 Nm (53 in-lb).
Installing a Two-piece Worm Drive Clamp
Measure the circumference you want to clamp and adjust the broadband to this length. Adjust the worm screw clamp to the desired length and spot weld both parts to the broadband. Release the worm screw clamp and place the clamp band around the material to be clamped, press the ribbon end with the perforation under the flap of the lock and close it. You can now tighten the worm screw clamp to the desired clamping force.
Product code:
18000118
Specifications
| Tightening torque: | 4-5 Nm (6 Nm Maximum) |
| Bandwidth: | 12,2 mm |
| Bolt: | SW 5 mm Allen Screw |
